xi
How to Use This Manual
To get the maximum benefit of your new Haas machine, read this manual thoroughly and
refer to it often. The content of this manual is also available on your machine control under
the HELP function.
IMPORTANT: Before you operate the machine, read and understand the Operator’s
Manual Safety chapter.
Declaration of Warnings
Throughout this manual, important statements are set off from the main text with an icon
and an associated signal word: “Danger,” “Warning,” “Caution,” or “Note.” The icon and
signal word indicate the severity of the condition or situation. Be sure to read these
statements and take special care to follow the instructions.
Description Example
Danger means that there is a condition or situation
that will cause death or severe injury if you do not
follow the instructions given.
DANGER: No step. Risk of electrocution, bodily
injury, or machine damage. Do not climb or stand
on this area.
Warning means that there is a condition or situation
that will cause moderate injury if you do not follow
the instructions given.
WARNING: Never put your hands between the
tool changer and the spindle head.
Caution means that minor injury or machine
damage could occur if you do not follow the
instructions given. You may also have to start a
procedure over if you do not follow the instructions in
a caution statement.
CAUTION: Power down the machine before you
do maintenance tasks.
Note means that the text gives additional
information, clarification, or helpful hints.
NOTE: Follow these guidelines if the machine is
equipped with the optional extended
Z-clearance table.
To Next Page
Loading...
