xiv
Chapter 5 G234 - Tool Center Point Control (TCPC) . . . . . . . . . . . . . . . . .33
5.1 G234 - Tool Center Point Control (TCPC) (Group 08) . . . . . . . . . 33
Chapter 6 G254 - Dynamic Work Offset (DWO) . . . . . . . . . . . . . . . . . . .37
6.1 G254 - Dynamic Work Offset (DWO) (Group 23) . . . . . . . . . . . . 37
Chapter 7 Setting Work and Tool Offsets . . . . . . . . . . . . . . . . . . . . . .41
7.1 Set the B-Axis Work Offset . . . . . . . . . . . . . . . . . . . . . . . 41
7.2 Set the C-Axis Work Offset . . . . . . . . . . . . . . . . . . . . . . . 41
7.3 Set the X-, Y-, and Z-Axis Work Offsets Manually. . . . . . . . . . . . 42
7.4 Set the X-, Y-, and Z-Axis Work Offsets with WIPS . . . . . . . . . . . 46
Chapter 8 Rotary Unwind and Setting 247 . . . . . . . . . . . . . . . . . . . . . .49
8.1 Quick Rotary G28 (Home) . . . . . . . . . . . . . . . . . . . . . . . . 49
8.2 247 - Simultaneous XYZ Motion in Tool Change . . . . . . . . . . . . 49
Chapter 9 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .51
9.1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 51
9.2 UMC-750 Maintenance Schedule . . . . . . . . . . . . . . . . . . . . 51
9.3 More Information Online . . . . . . . . . . . . . . . . . . . . . . . . . 54
Index. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .55
To Next Page
Loading...
Need help?
General
