Safety
3
2. Adding lubricants
• Adding lubricants for spindle and axes is required at regular intervals. These
are often months or years in length. This is a normal operator function and is
always done from a safe location outside of the work enclosure.
3. Cleaning chips out of the machine
• Cleaning out of chips is required at intervals dictated by the type of machining
performed. This is a normal operator function. It is performed with the doors
open and all of the machine operation is stopped.
Service only consists of the following:
1. Repairing of a machine that is not operating correctly
• Any machine that is not operating correctly requires service by factory trained
personnel. This is never an operator function. It is not considered
maintenance. Installation and service instructions are provided separately
from the Operator’s Manual.
2. Machine moving, unpacking, and installation
• Haas machines are shipped to a user’s location almost ready to operate. They
still require a trained service person to complete the installation. Installation
and service instructions are provided separately from the Operator’s Manual.
3. Machine packing
• Machine packing for shipment requires the same packing material supplied by
Haas in the original shipment. Packing requires a trained service person to
complete the installation. Shipping instructions are provided separately from
the Operator’s Manual.
4. Decommission, dismantle and disposal
• Machine is not expected to be disassembled for shipment; it can be moved in
its entirety in the same manner in which it was installed. Machine can be
returned to the manufacturer’s distributor for disposal; manufacturer accepts
any/all components for recycling per Directive 2002/96/EC.
5. End-of-life disposal
• End-of-life disposal must conform to the laws and regulations in the region the
machine is located. This is a jointly the responsibility of the owner and seller of
the machine. The risk analysis does not address this phase.
To Next Page
Loading...
