52
SECTION 5, continued
5.2.1.1 Assembling the Support Stand
1. Verify the sample compartment is empty, and turn the instrument off.
2. Turn the instrument on its top (place it on a soft cloth to protect the instrument
from marring), and install the base plate of the stand as illustrated in Figure 10.
DO NOT OVERTIGHTEN THE SCREWS.
3. Place the instrument right side up.
4. Install the Flow-Cell Inlet Reservoir on to the support rod.
5. Slide the Collection Drain Assembly on to the support rod.
6. Place the instrument right-side up, and install the support rod into the base.
Tighten the thumb screw to secure the rod.
Figure 10 Base Plate Installation
Base
To Next Page
Loading...
