Need help?Do you have a question about the Hach BioTector B3500C and is the answer not in the manual?
General| Operating Temperature | 5 - 40 °C |
|---|---|
| Power Supply | 100 - 240 VAC, 50/60 Hz |
| Self-Cleaning | Yes |
| Weight | 25 kg |
| Parameter | TOC |
| Measurement Principle | High-Temperature Oxidation |
| Measurement Range | 0-20000 ppm |
| Detection Limit | 0.1 mg/L |
| Sample Volume | 10 mL |
| Sample Temperature | 2 - 60 °C |
| Outputs | 4-20 mA, USB |
| Communication | Modbus, Ethernet, USB |
| Data Storage | Internal memory |
| Calibration | Automatic |
| Dimensions | 600 mm x 450 mm |
Explains the meaning of safety symbols used in the manual for hazard communication.
Details the various labels attached to the instrument and their meanings for safe operation.
Summarizes the certification marks on the instrument and their significance for compliance.
Identifies potential hazards associated with the BioTector system during operation.
Provides essential safety guidelines to be followed during installation, operation, and maintenance.
Describes the BioTector software interface, key screens, and menu navigation.
Details how to start, stop, and manage the BioTector analyzer's operational functions.
Explains the process for calibrating the analyzer, including zero and span calibration procedures.
Provides comprehensive details on the BioTector's features, including display, data storage, and operation.
Outlines the standard and optional input/output signal specifications for system integration.
Lists additional features available for the BioTector, such as remote control and industrial interfaces.
Identifies and describes the main physical components of the BioTector analyzer.
Provides an overview of how the BioTector analyzer functions and its operational principles.
Specifies the essential requirements for power, signal, air supply, and reagent connections.
Guides the user through the process of unpacking and physically installing the BioTector analyzer.
Details the correct procedures for connecting air supply lines and chemical reagent containers.
Explains how to properly connect sample intake, drain, and exhaust lines for system operation.
Describes the acid and base reagents used by the BioTector and their consumption rates.
Provides guidelines for preparing calibration standard solutions for accurate analysis.
Details the initial inspection and connection checks required before analyzer startup.
Guides the user through the analyzer power-up sequence and initial setup adjustments.
Outlines the critical steps for performing zero and span calibration to ensure accurate measurements.
Provides access to various diagnostic tools for system testing and troubleshooting.
Contains settings for configuring the analyzer based on specific site requirements during startup.
Allows for detailed configuration of system parameters, analysis modes, and programs.
Explains system faults, their causes, and the recommended actions for resolution.
Details system warnings, their causes, and the steps to take for remediation.
Describes notification events, their conditions, and the appropriate cause/remedy.
Lists routine checks to be performed weekly to ensure optimal system performance.
Provides a checklist for recommended periodic maintenance tasks every six months.
Lists system components and spare parts available for replacement or maintenance.
Presents the manufacturer's declaration of conformity with relevant European directives and standards.
States the BioTector TOC Analyzer's compliance with specific European/Irish standards for water analysis.
Outlines the terms of the BioTector warranty, coverage, exclusions, and limitations.
Provides definitions for technical terms and abbreviations used throughout the manual.
Lists contact details for HACH Company and its international distributors for support.
To Next Page
