80
After the program is copied, enter the calibration data into the program by
using one of the methods described in 3.10 Creating A User Program,
starting at Step 23.
1. Turn the instrument on with the
I/O key. After the self-test the display
will show:
2. Press
SHIFT USER PRGM to go to the Create Program menu.
The display will show:
3. Press the
DOWN ARROW three times. The display will show:
4. To copy the program, press
ENTER (if not, press EXIT). The display will
show (for example):
5. If the flashing program number is not correct, enter the correct
number with the
NUMERIC keys or scroll through the available list of
user-entered programs using the
ARROW keys. Then press ENTER when
the correct number appears (this is the source program).
nm
+8.8.:8.8.
ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
*
Enter Proçram #
nm
+8.8.:8.8.
ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
*
Create Proçram
nm
+8.8.:8.8.
ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
*
Coðù Proçram
nm
+8.8.:8.8.
ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
888500
*
Coðù 968 ~ ___
To Next Page
Loading...
