Hach H160 - Meter Setup Functions; Set Stabilization Lock on or off

Operation
14
4.3 Meter setup functions
4.3.1 Set stabilization lock ON or OFF
pH, conductivity, TDS can be displayed with a stabilization lock mode. When a
stable indication is reached, the display locks on the value and the meter ignores
very slight changes in the measurement. The READY icon turns on when an
endpoint is reached and the stabilization lock is active. The display automatically
unlocks after a significant measurement change is detected. When performing
titrations or attempting to detect very slight changes, the stabilization lock should be
OFF.
6
TDS or salinity mode value is in mg/L or g/L
•
7
TDS or salinity value is ppm
•
8
TDS or salinity value is in ppt
•
9
The displayed value is a mV value
••
10
The displayed value is a pH value
••
11
the conductivity value is in mS
•
12
The conductivity value is in µS
•
13
The salinity value is in %
•
14
The pH, Conductivity, TDS or Salinity value is automatically
temperature compensated.
•
15
The meter is in a calibration mode and when calibrating it
indicates the point of a multiple point calibration
••
16
The Temperature value is in °F
••
17
The Temperature value is in °C
••
18
Low power indicator
••
19
Meter is in setup mode
••
20
Temperature value
••
21
Main display value
••
22
Stable indication (endpoint) in pH, Conductivity, TDS or Salinity
•
23
The display is in HOLD mode
••
Item
No
Description H160 H170