Operation
18
To change or set the meter shutoff time:
1. Push the SETUP key to put in the setup mode.
2. Push the arrow keys until the meter automatic shutoff time screen is displayed.
3. Push ENTER. The display will show the number of minutes until the meter
automatically shuts off.
4. Use the numeric keypad or the arrow keys to set the shutoff time in minutes.
Set to 000 for continuously on.
5. Push ENTER to save changes and return to setup mode.
6. Push SETUP to return to setup mode without saving changes.
4.3.5 Clearing calibration points
It is possible to clear all stored calibration points for all parameters. It is important to
recalibrate the meter prior to use after clearing all calibration points.
To clear calibration points in the meter:
1. Push the SETUP key to put in the setup mode.
To Next Page