10
Installation
3.3 Power connections
Install the correct adapter plug on the supplied external power
supply (Figure 1). Slide the adapter on until it "clicks" into position.
Plug the external power supply cord into the connector on the back
panel of the instrument, then plug the supply into a power outlet
(100–240 V~ / 50–60 Hz). Press the power switch on the back of
the instrument to initialize power (Figure 2 on page 11).
Figure 1 Power adapter
1 Power supply with EU adapter plug installed 3 USA adapter plug
2 UK adapter plug 4 AUS/China adapter plug
To Next Page
Loading...
