34
Standard Operations
1. Plug in the USB device (Figure 2 on page 11).
2. Press Recall Data from the Main Menu. Press Options and
then the PC & Printer icon.
3. Select the data to send to the memory stick and press OK.
Note: The number in parenthesis is the total number of data sets
assigned to this selection.
To send measurement data to a PC:
The optional HACH Data Trans software must be installed on the
PC for the subsequent to process for measurement data.
1. Press PC & Printer in the Instrument Setup.
2. Select PC.
3. Press Setup to display the PC Setup screen.
For further installation instructions, refer to the HACH Data
Trans user manual.
4. Select Auto-Send: On to send all measured data automatically
to the PC.
Note: If Auto-Send: Off is selected, the "PC & Printer" key must be
pressed, in order to send data to the PC.
The remote function is only for monitoring the data transfer.
To Next Page
Loading...
