Transmitter 9125 – Conductivity / resistivity measurement
Page 24
Modification of a value
The highlighted digit may be modified with the key
. Each digit can be validated by pressing
ENTER. Repeat both operations for each digit.
Note :
If you do not use the display for at least 10
minutes, the instrument returns to the
measuring mode except for the calibration and
maintenance mode.
An access code may be required for the
calibration, programming and service menu (see
CODE menu).
Measures display
Measures display allow to display measures and state
of the device. There are three :
Reference Description
c
Main display
d
Alarm state
e
Function keys
26.8
mS/cm
25.0°C
Disp2 Menu
S1
S2
S3
S4
To Next Page
Loading...
