12
4. Installation of indoor unit group
310
30
530
80
510
0~5mm
Note: When the dimension of the master part does not match with the hole of the ceiling, adjust the slot of
the hanging bracket.
Adjusting to level
a. Conduct leveling adjustment by using gradienter or the
following methods.
Conduct adjustment so as to make the relationship between
the bottom surface of the unit and the unleveled surface in
the hose show as the following diagram.
One side of pipeline
water injection
horizontal plane
make the pipeline a little lower
PVC pipe
b. Unless adjusted to the horizontal position, otherwise the floating switch may have fault or misplay.
liquid pipe
gas pipe
electrical cabinet
above
air inlet
air outlet
interface of drainpipe
below
Fix the indoor unit to the hoisting screw stem.
If necessary, the unit may be hung to the crossbeam.
If there is no hoisting screw stem, directly use the bolt.
M10 nut
Hoisting screw stem
M10 washer
main
unit
M10 spring washer
Model Liquid pipe (mm) Gas pipe (mm)
AD322FIAHA
AD362FIAHA
AD452FIAHA
*9.52
*15.88
*9.52
*19.05
*9.52
*19.05
VP 25 polyethlylene pipe
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
