118
AB092FEAIA
AB122FEAIA
AB142FEAIA
AB162FEAIA
Step (Sequence)
Category
Repair part
Points for attention
18. Decomposition method
a. Indoor unit
(1) Cassette type with airflow in four directions
Air outlet
grill
1. Remove the installing screws on both sides and remove the grill
Remove from the air outlet
Air inlet
grill
1. Operate the grill locking button, open the air inlet grill
2. Remove the lifting rope
3. Lift the rotary shaft of air inlet grill and remove it
Can adjust the grill locking button,
only direction moving
Air filter
screen
Remove the screw for fixing air filter screen on the lockingbutton side of air inlet grill and slide the block to the outside
Before installation, hang grill lockingbutton
Air swingvane
Before decomposition, confirm the
assembly state and install as per the
original state.
Electric
control box
1. Remove the air inlet grill
2. Remove the casing of the electric control box
3. Inspection
The casing removed must be
resumed
Eccentric fan
*1 Remove the installing screwon the electric control box
2. Turn 90* of the electric
control box
3. Remove the medium-sized
inlet sleeve
4.Remove the screw for
installing the fan
5.Remove the fan
6. Remove the motor
(Tightening torque: 2.9N.m)
1. Confirm that the pushing bar for
fixing the turbine fan is really
entered into the concave part,
then fix the nut.
2. For the fixing nut of turbine fan, please fix it with left value, excess fixing will lead to noise.
Fan motor
~
*1 Remove the electriccontrol box and outlet screen2. Remove the screw for
installing the fan
3. Remove the fan
4. Remove the motor(Tightening torque: 3.9N.m)
Drainage
pump
*1 Remove the fan motor
2. Remove the cover of
drain pump3. Remove the screw on the installing plate of drain pump4. Pull out the drain pump
forward
*1 Remove the water tray2. Remove the screw on the installing plate of drainage pump
3. Pull out the drainage
pump forward
1.Before lowering the water tray,
pull out the plug for discharging
water
2. When removing the water tray pallet , carefully confirm its original state, and do not make mistake
when assembling.
Floating
switch
*1
Remove the air outlet grill cover on the electric control box
2. Remove the fixing plate of water tray with four corners3. Remove the drain hose
4. Remove the floating switch
5. Remove the TC sensor
For the assembly after
decomposition, please clamp the
leading wire; do not touch the fan
and heater.
TC sensor
Drainage
hose
1. Remove the fixing plate of refrigerant pipe
2. Pull out the drain hose in the unit
3. Pull out the water pipe.
Water tray
1. Conduct operation from the
inspection port
2. Before entering into the step,
please remove the water pipe
Heat exchanger
(Distribution
panel)
*1
Remove the electric control box of refrigerant pipe cover
2. Remove the water tray
3. Remove the fixing screw for heat exchanger
4. Remove the heat exchanger
Remove the TC sensor in advance
Panel
Parts
*1 Remove fan cirde.
2.
Remove the fixing plate of drain hose with four corners
AB182FEAIA
AB242FEAIA
AB282FEAIA
AB322FEAIA
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
