Hakko Electronics FM-202 User Manual

rxic
^HAK<^
SOLDERINO STUTION
MODEL
FM-202
High-output, temperature controlled
soidering station
Instruction Manual
Thank you for purchasing the FM-202 soldering station. This
high-output, temperature controlled soldering station uses a
composite tip, incorporating heater and sensor functions into
one element. Several process Control features, unique to the
FM-202, make it applicable to a broad range of soldering ap-
plications.
Piease read this manual before operating the FM-202. Keep
this manual readily accessible for reference.
TABLE OF CONTENTS
1. PACKING LIST.1
.2. SPECIFICATIONS.1
3. WARNINGS, CAUTIONS, NOTES AND EXAMPLES.2
4. PART N AM ES.3
5. INITIAL SETUP.3
6. OPERATION.5
7. TIP IDENTIFICATION NUMBER.9
8. PARAMETER SETTINGS.10
9. MAINTENANCE.12
10. ERROR MESSAGES.14
11. TROUBLE SHOOTING GUIDE.15
12. PARTS LIST.17
13. TIPSTYLES .20
14. APPENDIXA.22
15. WIRING DIAGRAM.23

Hakko Electronics FM-202 Specifications

General

Type	Soldering Station
Temperature Control	Digital
Heating Element	Ceramic
Temperature Stability	±1 °C
Tip to Ground Potential	< 2 mV
Standby Mode	Yes
Tip to Ground Resistance	<2 ohms
Weight	1.2 kg
Tip Replacement	Tool-free
Power Consumption	70W
Voltage	24V
Temperature Range	200°C to 480°C (392°F to 896°F)

Summary

Specifications

FM-202 Soldering Station Specs

Detailed specifications for the FM-202 soldering station unit.

Station Unit Specifications

Technical details regarding the station's output, dimensions, and weight.

Soldering Iron Specifications

Technical details regarding the soldering iron's power, resistance, and length.

Safety Warnings and Cautions

Operational Cautions and Guidelines

Important safety warnings and operational cautions to prevent injury and damage.

Initial Setup Procedures

Operating the FM-202

Changing Temperature Settings

Step-by-step guide to adjust the soldering station's temperature using the control card.

Tip Identification and Entry

Entering Tip ID Data

Explains how to electronically compensate for tip geometry variations using Tip IDs.

Parameter Settings Configuration

Maintenance Procedures

Error Messages and Codes

Sensor Error (S-E)

Indicates a failure in the sensor or heater circuit, leading to power shutdown.

Low-Temperature Alarm Error (H-E)

Triggered when temperature drops below the set alarm tolerance.

Troubleshooting Common Issues

Unit Not Operating

Troubleshooting steps if the unit does not power on.

Tip Not Heating Up

Diagnosing issues when the tip fails to heat, including sensor errors.

Soldering Tip Styles Catalog

Wiring Diagram