Hakko Electronics Monitouch V7 Series - Page 39

2-14 5. Modular Jack (MJ1/MJ2)
*8 Refer to “EU-01 (RGB input + sound output unit)”.
*9 Select this option when using the ladder transfer function.
*10 Select this option for Modbus slave connection.
*11 Select this option when connecting the printer with serial interface.
Refer to page 2-20.
Combination of MJ1 and MJ2 Functions
: Usable at the same time.
: Usable at the same time with V-SFT 2.0.2.0, SYSTEM PROG Ver. 1.010 and later
: Not usable at the same time
Combination of Communication Unit (CU-xx) and Modular Jack Function
: Usable at the same time. : Not usable at the same time
*1 This is not possible when the V7 series and the PLC are connected via Ethernet.
MJ1
MJ2
Multi-
Link 2
Card
Recorder
Barcode V-I/O
Temp./PLC
2Way
V-Link
Touch
Switch
Ladder
Tool
Modbus
Slave
Printer
(Serial Port)
Multi-
Link 2
Card
Recorder
Barcode
V-I/O
Temp./PLC
2Way
V-Link
Touch
Switch
Ladder
Tool
Modbus
Slave
Printer
(Serial Port)
Supplemental Remark:
Multi-link communication and temperature control network/PLC2Way can be used at the same time.
MJ
Communication Unit
Multi-
Link 2
Card
Recorder
Barcode V-I/O
Temp./PLC
2Way
V-Link
Touch
Switch
Ladder
Tool
Printer
(Serial
Port)
Built-in
Ethernet
CU-00 OPCN-1
CU-01 T-LINK
CU-02 CC-Link
CU-03(-2) Ethernet
*1
CU-03(-2) FL-net
CU-04 PROFIBUS-DP
CU-05 MELSECNET/10