15
First Operation
2.5 Operation
Scrubmaster B45
1. Switch the machine on at the main
switch. The suction turbine is
switched on.
2. Lower the squeegee using the
sque
egee lever.
3. Lower the brush head using the foot
ped
al.
4. Draw back the bar on the bail sys-
tem. The brush head drive and solu-
tion supply are switched on.
5. Set the solution quantity with the
han
d valve.
6. Push the machine. The power flow of
the brush head drive supports the
forward drive.
Start driving immediately after
switching on the brush head
drive othe
rwise imprints of the
brush could be produced on
the floor. Raise the brush head
when driving over thresholds.
Scrubmaster B45 CL
1. Switch the machine on using the key
switch. All
the units are in Standby
2. Lower the squeegee using the
squee
gee lever. The suction turbine
is switched on.
3. Lower the brush head using the foot
ped
al.
4. Draw back the bar on the bail sys-
tem. The brush head drive and solu-
tion supply are switched on.
5. Set the solution quantity using the
button on the ope
rating panel.
6. Set the driving direction and speed
using the bail
system.
7. To alter the cleaning intensity of the
cleaning process, use the buttons on
the operating panel to change the
solution quantity and switch the solu-
tion supply on and off.
Start driving immediately after
switching on the brush head
drive otherwi
se imprints of the
brush could be produced on
the floor. Raise the brush head
when driving over thresholds.
To Next Page
Loading...
