8
cribed aSafety information
1.3 Operating information
• Before starting the machine up for
the first time,
the battery to be used
must be fully charged, properly, by
implementing the initial battery
charge routine. Please pay attention
to the operating manual provided
with the charging unit as well as the
manual from the battery manufactur-
er. Hako assumes no liability for
da
mage to the battery caused by a
fault when the battery is charged for
the first time.
• Check the operational safety of the
machi
ne each time before starting it
up! Clear any faults immediately!
• Before starting work, the operator
must
be fully familiar with all adjust-
ment, operating and control ele-
ments as well as their respective
function
! It is too late to do this when
the machine is actually in operation!
• Always wear heavy duty, non-slip
footwea
r when working with the ma-
chine.
• The machine may only be driven on
an
d the equipment used on those
surfaces which have been approved
by the contractor or person appoint-
ed by him.
• This vehicle is not intended to be
used
by persons (including children)
with limited physical or mental capa-
bilities or persons without sufficient
expe
rience and ability.
• When using the machine, it is essen-
tial to pay attention to third parties,
espe
cially children.
• Start driving immediately after
switchin
g on the brush head drive
otherwise imprints of the brush could
be produced on the floor.
• Only use cleaning agents suitable for
the vendor (non-foaming) and ob-
serve all the use, disposal and warn-
ing information provided by the
clea
ning agent manufacturer.
• Only open empty recovery tanks.
• The machine is not suitable for clear-
ing up hazardous, inflammable or
expl
osive fluids, dust or substances.
• It is forbidden to use the machine in
potentially explosive atmospheres.
• To prevent unauthorized use of the
machine, remov
e the key from the
main switch (Scrubmaster B 45 CL)
only).
• When transporting the machine, the
squeegee and brush head must be
raised. The way of driving must be
adapted to the local conditions.
• The machine has been conceived for
use on le
vel surfaces with a maxi-
mum gradient of 2%.
To Next Page
Loading...
