*#1 :-%Owner’s Manual
58
In this mode, you can name your Combination Presets and determine how to recall
them.
To locate this mode:
Touch the [MENU/EXIT] button and display MENU, then touch the [PAGE] button to select
PAGE A and touch the [2] PRESET button.
PRESET
PRESET NAME
1. Preset Name (P)
This allows you to name the present Combination Preset using up
to 10 letters.
Move the cursor by the [PARAM] button, and choose the letters
by the [VALUE] button or the [VALUE] knob.
This change will be lost if you do not record it, same as the other
Preset Parameters.
NOTE: The parameters by the names with (P) on the end are Preset
Parameters, and are recorded to each Combination Preset.
PRESET LOAD
This allows you to set the operation when you depress the Preset
Key.
2. PRESET LOAD - UPPER (B)
This allows you to set whether or not to recall the Drawbar Reg-
istration of UPPER Part.
3. PRESET LOAD - LINK LOWER/PEDAL (G)
This allows you to determine whether or not to recall the Draw-
bar Registration of the LOWER and PEDAL Part.
4. PRESET LOAD - DRAWBAR (B)
This allows you to determine whether or not to recall the Param-
eters relating to the Drawbars of each Part, such as the Tonewheel
Set.
5. PRESET LOAD - PERCUSSION (B)
This allows you to determine whether or not to sound PERCUS-
SION with the Preset Keys other than [B] Key and recall the
Parameters relating to Percussion.
6. PRESET LOAD - INTERNAL ZONE (B)
This allows you to determine whether or not to recall the Param-
eters relating to the Internal Zone such as SPLIT or MANUAL
BASS.
7. PRESET LOAD - EXTERNAL ZONE (B)
This allows you to determine whether or not to recall the Param-
eters relating to the External Zone to control the external MIDI
equipment.
8. PRESET LOAD - EQ/RV (B)
This allows you to determine whether or not to recall the Param-
eters relating to the EQUALIZER and REVERB.
9. PRESET LOAD - ANI/OD (B)
This allows you to determine whether or not to recall the Param-
eters relating to VIBRATO, OVERDRIVE and LESLIE.
10. PRESET LOAD - KNOB & BUTTON (B)
This allows you to determine whether or not to recall the Param-
eters relating to ASSIGNABLE CONTROLLERS.
NOTE: Each Parameter (B) of Preset Load is a Bank Parameter (ex-
cept Link Lower/Pedal). It is set only for the BANK currently
selected. Link Lower/Pedal is a Global Parameter. It is com-
mon on all the BANKs.
3
1
2 3 4 5 6 7
8 9 10
To Next Page
Loading...
Need help?
General
