Hangar 9 Solo - Apply Epoxy to Wing Halves for Joining

12
13. Coat one half of the dihedral brace with epoxy up to the
center line drawn in Step 6. Install the epoxy-coated side of the
dihedral brace into the wing joiner cavity up to the center line,
making sure the “V” of the dihedral brace is positioned correctly
(with the wing upside down, the “V” will also be upside down).
14. Apply a generous amount of epoxy into the wing cavity of
the other wing half.
15. Smear epoxy on all sides of the exposed area of the dihedral
brace and uniformly coat both wing roots with epoxy.
CONTINUED
Section 2: Joining the Wing Halves