Warning
Hot hydraulic oil and parts will cause injury.
DO NOT touch the hot hydraulic oil and
parts.
②Dismantle rubber mat and front
soleplate.
③Dismantle filter and deal with local
regulation.
④Clean pedestal of filter, confirm that
the old gasket of pedestal is clean.
⑤Apply small amount hydraulic oil on
the new filter gasket.
⑥Install filter by hand. When the filter get
to pedestal, screw down an additional 1/2-3/4
turn.
5. Change hydraulic transmission oil (first
time, then semiannually)
Park truck on level ground, lay-down the fork
to the floor, incline the mast back, apply
parking brake, put transmission in neutral
position, and shut off engine.
Warning
Hot hydraulic oil and parts will cause injury.
DO NOT touch the hot hydraulic oil and
parts
①Put one case (volume is over 20 liters)
under the transmission.
②Remove oil plug and drain oil.
③Clean oil plug then install.
④Take out the dipstick. Add hydraulic oil.
See Table for the oil used in the truck, and
then install dipstick.
⑤Startup engine. Step the brake pedal,
get the engine idle running, place the
transmission in forward and backward so that
the oil enters the clutch.
⑥Place transmission in neutral, apply
parking brake.
⑦Take out the dipstick, inspect fluid
position. If oil is not enough, add oil to keep it
between max and mix marks。
⑧Check the filter and oil plug for leaks.
⑨Shut off engine, install front soleplate.
6. Air-bleeding fuel system [Diesel]
During fueling or draining water from
separator, it‘s also necessary to bleed air in
the fuel system.
①Loosen the bleed plug;
②Press the priming pump until fuel comes
through the bleed plug without any bubbles;
③Fasten the bleed plug;
1. Oil-water separator draining [Diesel]
Except Cummins Diesel：
①Position an approved container under the
fuel filter to collect the contaminants.
②Loosen the drain cock (2) at the bottom of
the fuel filter Drain any water collected
inside.
③Hand tighten the drain cock.
④Be sure to prime the diesel fuel system
when you are done.
Cummins Diesel：
Can type：
①Shut the engine;
②Place a container under the fuel filter;
③Uplift the drain valve control rod until
the liquid is completely drained and see clean
fuel;
④Push up drain rod until the liquid is
completely drained.
To Next Page
Loading...