EasyManuals Logo

Hanna Instruments HI98190 User Manual

Hanna Instruments HI98190
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
28
Wrong slope
The calibration cannot be confirmed.
This message is displayed if slope is out of the accepted range.
Slope under accepted value (30 % default slope).
Slope over accepted value (130 % default slope).
Wrong old slope
An inconsistency between new and previous (old) calibration is detected. Clear old calibration
parameters and proceed calibration from the current point. The instrument will keep all confirmed
values during current calibration.
The instrument will display “‑‑‑‑” on the primary LCD if is not calibrated or after all calibrations are
cleared.
If “Clear is pressed during the first calibration point, the instrument returns to measurement
mode.
Notes: Press T functional key or MODE to select temperature value to be changed if the
temperature probe is not connected.
ISE range is not temperature compensated.
ISE CALIBRATION HI98191

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hanna Instruments HI98190 and is the answer not in the manual?

Hanna Instruments HI98190 Specifications

General IconGeneral
BrandHanna Instruments
ModelHI98190
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals