Hanna Instruments reserves the right to modify the design, construction or appearance of its products
without advance notice.
Recommendations
for Users
Before using Hanna products, make sure that they are entirely suiable
for your specific application and for the environment in which they
are used. Operation of these instruments may cause unacceptable in‑
terferences to other electronic equipment. Take all necessary steps to
correct such interferences.
During operation, ESD wrist straps should be worn to avoid possible
damage to the electrode by electrostatic discharges.
Any variation introduced by the user to the supplied equipment may
degrade the instruments’ EMC performance.
To avoid electrical shock, do not use these instruments when voltages
at the measurement surface exceed 24 Vac or 60 Vdc.
To avoid damage or burns, do not perform any measurement in mi‑
crowave ovens.
The HI98190 and HI98191 are warranted for two years against defects in workman‑
ship and materials when used for their intended purpose and maintained according
to instructions. Electrodes and probes are warranted for six months. This warranty
is limited to repair or replacement free of charge.
Damage due to accidents, misuse, tampering or lack of prescribed maintenance is
not covered.
If service is required, contact the dealer from whom you purchased the instrument.
If under warranty, report the model number, date of purchase, serial number and
the nature of the problem. If the repair is not covered by the warranty, you will be
notified of the charges incurred. If the instrument is to be returned to Hanna Instru‑
ments, first obtain a Returned Goods Authorization (RGA) number from the Technical
Service department and then send it with shipping costs prepaid. When shipping any
instrument, make sure it is properly packed for complete protection.
Warranty
To Next Page
Loading...
Need help?
General
