Preparation before use
EN
Copyright © Qingdao Hantek Electronics Co., LTD Tablet1000 Quick guide
13
5 Preparation before use
5.1 Connect the power supply
The oscilloscope is equipped with 4 3.7V 2600 mAh batteries.
Press the power button, the buzzer rings, and the instrument starts up. Press the power
button again, the instrument shuts down. Before starting, please make sure the batteries
have enough power.
When the battery box on the screen is blank, it indicates that the battery is about to run
out.
When the battery level is lower than 3.5V, the oscilloscope will prompt "shut down after
30s". Tap the screen to cancel the popup box. "Shutdown after 20 seconds" and
"shutdown after 10 seconds" will appear subsequently. To avoid automatic shutdown due
to insufficient power supply, please charge in time.
If the power button is pressed and the buzzer rings continuously but the oscilloscope
doesn’t respond, it may indicate that the battery power may be exhausted. Please
charge in time.
You can charge the oscilloscope in the following ways:
Charge the oscilloscope through the power adapter: connect the oscilloscope to the
power socket through the USB data cable and the power adapter in accessories for
charging.
When charging, if the machine is not started, the indicator light of the power button will
be on; If the machine is turned on, the battery box on the screen will change (slow
charge , quick charge ).
When the battery is full, the oscilloscope will stop charging automatically.
5.2 Boot check
Press the power button at the bottom of the right panel to start the instrument.
Shutdown:
⚫ Tap the shutdown icon at the top of the main interface to shut down directly.
⚫ In the boot state, press the power button to shut down directly.
5.3 Set the system language
This oscilloscope supports Chinese and English. Click [HOME] to enter the main
interface and click [Settings] > Language to select the language.
To Next Page
Loading...
