Need help?Do you have a question about the Hantek TO1252D and is the answer not in the manual?
General| Bandwidth | 25 MHz |
|---|---|
| Channels | 2 |
| Vertical Resolution | 8 Bit |
| Vertical Sensitivity | 2 mV/div to 10 V/div |
| Power Supply | 100-240 V AC, 50/60 Hz |
| Multimeter | Yes |
| Input Impedance | 1 MΩ |
| Display | 7 inch LCD |
| Display Resolution | 800 x 480 |
| Trigger Modes | Edge, Pulse, Video, Slope |
| Connectivity | USB Host, USB Device |
| Sample Rate | 1 GS/s |
| Timebase Range | 5 ns/div to 50 s/div |
Lists crucial safety precautions to prevent injury and product damage.
Explains warning and note symbols used in the manual and on the product.
Defines measurement categories (Class I, II, III, IV) for instrument usage.
Specifies operating temperature, humidity, altitude, and vibration limits for safe use.
Covers connecting power, boot check, language, and probe compensation.
Details how to perform Fast Fourier Transform (FFT) for frequency domain analysis.
Explains how to set the trigger voltage level for stable waveforms.
Details edge trigger settings like rising, falling, and double edges.
Guides on setting triggers based on pulse width polarity and duration.
Details how to trigger based on the slope of a signal edge.
Guides on using automatic measurements for waveform analysis.
Defines time-related measurements like rise time, fall time, and duty cycle.
Lists various voltage measurements like Vmax, Vmin, Vrms, and variance.
Explains how to use vertical and horizontal cursors for measurements.
Describes acquisition modes: normal, average, peak, and high resolution.
Describes the self-calibration process and menu options.
Explains how Auto setting optimizes display for input signals.
Lists the available measurement functions for the multimeter.
Details various measurement types: voltage, current, resistance, capacitance, diode, continuity.
Guides on setting waveform type, frequency, amplitude, offset, and phase.
Details how to use the WaveEditor software to create arbitrary waveforms.
Details the process of upgrading the oscilloscope firmware.
Troubleshooting steps for no display after pressing the power button.
Troubleshooting steps for no waveform display on the input signal screen.
To Next Page
