Settings
EN
Tablet1000 User manual Copyright © Qingdao Hantek Electronics Co., LTD
76
Brightness
Use the slider to adjust the brightness.
Upgrade
The firmware can be upgraded using USB storage devices. The whole process takes
about two minutes.
Perform the following steps to upgrade the firmware:
1. Insert the USB storage device with only an upgrade package into the USB HOST
interface on the side panel of the oscilloscope.
2. Click [Setting] in the main interface to enter the setting interface.
3. Click Upgrade on the Setting interface and click the upgrade tab in the middle of the
screen to upgrade the firmware.
4. After the upgrade, the oscilloscope will restart and the firmware version will be
updated. The self-calibration should be performed after upgrade.
After the upgrade is successful, the saved files and pictures will be cleared.
Note: The USB storage device can contain only the upgrade file, and the name of
the upgrade file cannot be modified randomly as shown in the following figure.
Otherwise, the machine cannot be upgraded normally.
Automatic lock
Set the automatic lock time (screen-off time) and automatic shutdown time.
There are five automatic lock modes: 15S, 30S, 45S, 60S, and unlimited.
There are five automatic shutdown modes 15 minutes, 30 minutes, 45 minutes, 60
minutes and unlimited. The automatic shutdown time is the time when the machine will
shut down after the screen is turned off.
USB sharing
Follow these steps to perform USB sharing:
1. Connect the machine to the computer by USB.
2. Click USB sharing and click the USB sharing tab in the middle of the screen.
To Next Page
Loading...
