Need help?Do you have a question about the Hantek TO1154D and is the answer not in the manual?
General| Brand | Hantek |
|---|---|
| Model | TO1154D |
| Category | Test Equipment |
| Language | English |
Key safety precautions to prevent injury and product damage. Read before use.
Essential steps before operating the oscilloscope, including power and initial checks.
Guide on connecting the power source and ensuring sufficient battery charge for operation.
Procedure for calibrating probes to ensure accurate measurements and waveform display.
How to shift the waveform trigger point horizontally on the display.
Setting the time scale per grid for waveform analysis and zoom.
Setting the voltage scale per grid for optimal waveform amplitude viewing.
Positioning the waveform vertically relative to the screen's center.
Selecting AC, DC, or Ground coupling to filter signal components.
Applying bandwidth limiting to reduce high-frequency noise in measurements.
Manually setting the probe attenuation ratio for accurate amplitude readings.
Performing addition, subtraction, multiplication, and division on channel signals.
Converting time-domain signals to frequency-domain using Fast Fourier Transform.
Setting the voltage threshold for triggering waveform acquisition.
Selecting the input channel (CH1-CH4) for trigger signal detection.
Choosing between Normal, Automatic, and Single trigger modes for stable display.
Setting a delay after a trigger event to prevent re-triggering on subsequent events.
Selecting trigger conditions based on waveform edges, pulse width, video, slope, or timeout.
Triggering based on the rising or falling edge of a signal at a specific voltage.
To Next Page
