Reference channel
EN
Copyright © Qingdao Hantek Electronics Co., LTD Tablet1000 User manual
35
8 Reference channel
Save reference waveform
Click Utility > Save > Ref wave, then select reference data sources CH1~CH4. Click the
save icon below to open the Reference waveform menu, you can see the reference
waveform saved just now.
If a USB flash drive is inserted, then the reference waveform will be saved to the USB
flash drive. It is also necessary to plug in the USB disk to call the reference waveform in
the USB disk.
Reference waveform calling and closing
This series of oscilloscopes support calling reference waveform.
On the oscilloscope interface, click Next > Reference waveform.
If the reference waveform has been saved before, open the reference waveform menu
and the reference waveform file will be displayed.
Click to select a reference waveform file, and a pop-up box will prompt: Call out
successfully.
A gray reference waveform will appear on the screen.
Click the yellow bar , it will turn gray, indicating the reference waveform is
closed.
To Next Page
Loading...
Need help?
General
