Hantek TO1154D Quick Guide

Preparation before use
EN
Copyright © Qingdao Hantek Electronics Co., LTD Tablet1000 Quick guide
15
3) Check the shape of the displayed waveform
Figure 5.2 Probe compensation52
3) If necessary, adjust the variable capacitance on the probe with a non-metallic
screwdriver until the waveform displayed on the screen is "compensated correctly" as
shown above.
If necessary, repeat Step 3. The adjustment method is shown in the following figure.
Figure 5.3 Adjusting the probe53

Hantek TO1154D Specifications

General

Brand	Hantek
Model	TO1154D
Category	Test Equipment
Language	English