MS1000 Control System
Installation Guide
hanwell.com
Page 13 of 30 GD6063-1
4 Firmware/Software Requirements
4.1 Firmware
The Firmware is the customised ROM fitted either to the MS1000 Control Board or the
CR3/SR2 Controller depending on the type of System.
It is written to the supplied URS (User Requirement Specification).
A URS MUST BE SUPPLIED TO HANWELL SOLUTIONS PRIOR TO
THE SHIPPING OF THE MS1000 CONTROL SYSTEM
4.2 Software
The EMS application is used during the commissioning process to set up the MS1000
Monitoring and Control Systems and for monitoring data via the CR3/SR2 Controller during
normal operation.
4.2.1 New Systems
New systems will be supplied with the most recent version of the most appropriate software
application.
Stand-alone systems can be commissioned via a laptop connected to the RS232 Serial
lead within the MS1000.
A Serial/USB adapter will be required if the laptop does not have a Serial Port.
Monitoring and Control systems will require a PC with a Serial Port, running Windows 95
or later. If networked, there should be full access rights available during installation.
4.2.2 Existing Systems
See Section 10 Existing Hanwell EMS Users.
To Next Page