MS1000 Control System
Installation Guide
GD6063-1 Page 16 of 30
hanwell.com
7 Connecting the MS1000 Control System
7.1 Power Supply
The MS1000 Control Unit is powered from a single phase 240V 50Hz local mains supply from
a switched feed, fused at 3 Amps.
This is connected via a DIN rail mounted power supply, labelled with live, neutral and
earth, as shown in Figure 6 - Power Supply Connections.
+12V is generated internally to power the Output Cards and Control Board (if applicable).
The internal 0V reference is connected to local PE (Protective Earth).
Wiring supplying power to the Control Unit should be rated above 13A.
Figure 6 - Power Supply Connections
To Next Page