MS1000 Control System
Installation Guide
GD6063-1 Page 4 of 30
hanwell.com
1 Overview of the MS1000 Control System
The Hanwell MS1000 Control System is an interface between a Hanwell Environmental
Monitoring System (EMS) and 3
rd
party control equipment.
It is designed to generate either latched voltages or currents corresponding to inputs,
proportional to measured values, generated by sensors, in remote locations, that are
compatible with the Hanwell Environmental Monitoring System (EMS) software.
Typical applications could include:
Interfacing radio sensors to a Building Management System (BMS).
Conservation heating systems.
Bespoke heating control.
Providing signals to an Alarm Panel.
The MS1000 Control System can:
Allow radio sensors to directly replace wired-in sensors in applications such as building
environmental control where the 3
rd
party BMS can directly accept analogue signals.
Trigger relay outputs for alarm or control functions (e.g. motorised valves).
Provide a combination of all output types within a single MS1000 system.
To Next Page
Loading...