HANYOUNG NUX TD510 Series - Page 47

45
Installation
Before starting
Operation
Screen block
diagram
Function setting Program System setting Specifications
▶ Seg
1) Set Ch.1 temperature setting value of the segment.
2) Set Ch.2 temperature setting value of the segment.
3) Set operation time(H) of the segment.
4) Set operation time(M) of the segment.
5) Select the wait function set in "Pattern Management - Wait/Start."
Parameter Setting Default
Ch.1.SV EU(0 - 100) [℃] EU(0)
Ch.2.SV EU(0 - 100) [℃] EU(0)
Time [H] 0 - 9999 [H] 0
Time [M] 0 - 59 [M] 0
Wait Cancel, Set 0
[Seg parameter]
①
②
③
⑤
④
▶ T.S
Among 20 time signals, up to 4 of them can be selected for a segment.
n : 1~4
Parameter Setting Default
T.S #n 0~19 0
[T.S parameter]
그림 67) 세그먼트 설정
Fig. 68) Time signal