FINAL INSTALLATION
11
6.
To attach light kit fitter (D) to motor assembly (C),
align holes in switch housing cap with holes in
switch housing. (Make sure to align gap on top edge
of the switch housing cap with the reverse switch on
switch housing for the correct fit.) Re-insert screws
that were removed in Step 4 and use a Phillips
screwdriver to secure all screws. (Fig. 6)
Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled FOR LIGHT and remove
plastic that holds these two wires together. Also,
remove molex safety caps from bottom of BLUE
(or BLACK) and WHITE wires. It may be
necessary to pull firmly in order to remove molex
safety caps. (Fig. 5)
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter (D). Connect BLUE
(or BLACK) wire from switch housing to BLACK
wire from light kit fitter (D). Make sure that molex
connections are secure. (Fig. 5)
5.
Install three candelabra base 40-watt max.
bulbs (M) included. (Fig. 7)
Important: When you need to replace bulbs,
please allow bulbs and light kit to cool down
before touching the bulbs or the light kit.
7.
C
Switch
Housing
Switch
Housing
Cap
6
D
D
7
M
Switch
Housing
Cap Screw
Molex
Connections
5
Switch
Housing
D
Molex
Safety
Caps
To Next Page
Loading...
Need help?
General
