Hardi HC5500 User Manual

4 - System setup
22
Initial system start-up
When connecting the 39 pin plug from the sprayer, then note the one-
way brackets inside the connector and connector plug. There are two
different brackets to designate connector plug for respectively liquid (1)
and hydraulic (2) boxes.ATTENTION! The Controller/Terminal should be
protected from moisture and should be removed when not in use, if the
tractor does not have a cabin.
When connecting the 39 pin plug from the sprayer, then note the one-
way brackets inside the connector and connector plug. There are two
different brackets to designate connector plug for respectively liquid (1)
and hydraulic (2) boxes.
After connecting the plugs, the power is turned on at the Spray Box.
Model, software version number, number of sections and size are dis-
played briefly. At initial start up, Controller also promts for input of time
and date. [Set clock to enable register].
Press to continue.
μ
ATTENTION! At first start-up the clock must be set in order to
make the registers work properly. See “Menu 2.4 Set clock”.
Screen contrast adjustment
The screen contrast can be adjusted by pressing and then use the or to find the correct setting. This can only
be done when “driving screen” is active, i.e. not when any menus are active.
Note that this function will only be availeble on hardware version 2.0 and higher

Hardi HC5500 Specifications

General

Brand	Hardi
Model	HC5500
Category	Controller
Language	English