EasyManua.ls Logo

Hardt Blaze - Troubleshooting; Rotisserie Does Not Operate

Hardt Blaze
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 22 of 26 CUS-013-0044-01
6. Troubleshooting
SERVICE/REPAIRS SHOULD ONLY BE PERFORMED BY TRAINED PERSONNEL.
DISCONNECT POWER TO THE ROTISSERIE BEFORE ANY MAINTENANCE, SERVICE OR
CLEANING IS PERFORMED.
ROTISSERIES EQUIPPED WITH CASTERS ARE SECURED IN PLACE USING A RESTRAINING
CABLE LOCATED ON THE RIGHT REAR UNDERSIDE OF THE ROTISSERIE. THIS CABLE MUST
BE DISCONNECTED PRIOR TO REMOVING THE ROTISSERIE AND CAUTION MUST BE TAKEN TO
ENSURE IT IS CONNECTED ONCE THE ROTISSERIE HAS BEEN RETURNED TO ITS ORIGINAL
POSITION.
THE ROTISSERIE IS HOT WHEN OPERATING. EXERCISE CAUTION WHEN WORKING NEAR THE
HOT ROTISSERIE.
WEAR APPROPRIATE PROTECTIVE CLOTHING BEFORE ANY MAINTENANCE, SERVICE OR
CLEANING IS PERFORMED.
6.1. Rotisserie Does Not Operate
SYMPTOM:
The rotisserie does not operate when the red
main ON/OFF is pulled out (i.e. drive does
not turn, and oven light does not illuminate).
SOLUTION:
Check the rotisserie electrical power: If the
rotisserie's lights are off, check the circuit
breaker on the back of the rotisserie as
shown in Figure 6-1. If the circuit breaker is
‘OFF’ (tripped), return to 'ON'.
Verify that the door is fully closed. The door
switch disables the ignition system.
If this circuit breaker is ‘ON’, ensure that the
power cord is plugged into the wall and that
there is power coming from the socket.
If power is available and the rotisserie still
does not operate, contact your local
authorized service partner.
Figure 6-1
ON
OFF