Hardt Blaze - Numeric Temperature Display Mode

CUS-013-0044-01 Page 25 of 26
Do not touch the replacement halogen light bulb with bare fingers or dirty gloves.
6. Install a new halogen light bulb.
7. Position the halogen light support bracket so that the
light is oriented towards the center shaft of the
rotisserie and hand-tighten the two wing nuts.
8. Plug the power cord back into the wall receptacle.
9. Turn the rotisserie ON by pulling out the red main
ON/OFF switch.
10. Verify that the replaced halogen light bulb functions
correctly. It is normal for the halogen light bulb to take
about 6 seconds to illuminate after the red main
ON/OFF switch has been pulled out. If not, repeat the
first four steps of this procedure and make sure the
halogen light bulb was correctly inserted in the socket.
11. Reinstall the halogen light access panel.
12. Turn the rotisserie ON by pulling out the red main
ON/OFF switch and recheck.
13. If the problems persist, contact your local authorized
service partner.
Numeric Temperature Display Mode
If it is required to have the temperature display mode switched from Fahrenheit to Celsius or vice versa,
contact your local authorized service partner.