Harman P35I - Page 31

31
Pellets or Corn/Pellet Mixture Only
P35i Fireplace Insert
Save These Instructions 3-90-775R15_04/13
    Keep combustible
materials, gasoline and other ammable vapors and
liquids clear of the appliance.
• Do NOT store ammable materials in the vicinity of
the appliance.
• Do NOT use gasoline, lantern fuel, kerosene,
charcoal lighter uid or similar liquids to start or
"freshen up" a re in this appliance.
Keep all such liquids well away from the heater while it
is in use, as combustible materials may ignite.

Do NOT store fuel:
• Within the required clearance areas of the
appliance.
• Within the space required for fueling or ash
removal.
5. Cleaning Area Beneath Burn Pot Grate
• Frequency:Monthlyormorefrequentlydepending
onfuelqualityand/orashbuildup.
• By:User




5. Cleaning Heat Exchanger & Exhaust
• Frequency: Monthly or after each ton of fuel is
burned.
• By:User
It is recommended that you use a vacuum that is
designed for ash, as ashes may block conventional
vacuumlters.
NOTICE: For optimal performance of your pellet
burningappliance,youmustperformregularcleaning
andmaintenanceasdirectedinthismanual.Notdoing
sowillresultin:
 Poorperformance
 Smokespillageintotheroom
 Overheatingofcomponents
Failure to perform regular cleaning on your pellet
burningappliancewillvoidthewarranty.
a.Makesurethereisoutandcool.Disconnectpower
cordpriortoservicing.
b.Scrapethemajorityofashesintotheashpan.Begin
withthebackandroofabovetheburnpot.
c.Scrapetheashesfrombothsides,intotheashpan.
a.Loosenthetwowingscrewslocatedonthefrontof
theburnpothousing.
b.Liftthecoveroffofthewingscrewsandsetaside.
c.Usingyourash-vac, removeanyashes ordebris
fromtheairchamber.
d.Youcantapontheigniter,locatedabovethecleanout
hole.Thiswillhelptoremoveanyaccumulationon
theigniterelement.
e. Re-install the cleanout cover and tighten the
wingscrews.Besure thatthe coveris completely
coveringthehole,asairleakageheremayleadto
incompletecombustionorpoorignition.