Vi1000 USER MANUAL
12.0 12.0: METERING
12.0: METERING
Level metering in the Vi1000 goes from +18dB to -36 dB. It represents 4dB below the actual output level in dBu from
its analogue line output, i.e. 0 on the meter scale equals +4dBu at the analogue outputs. Gain reduction is displayed
in the Range 0 - 20dB. The Vi1000 uses full oating-point calculations in its DSP, which means that the audio signal
inside the mixer cannot be overloaded. If the signal level is too high at the master output meters, it is necessary only to
pull down the master fader level until the correct level is obtained.
There are meters on every channel and bus master, plus metering for every console path in the default Master Bay
touchscreen areas.
The touchscreen meters can be touched to assign the selected block of 8 inputs or bus masters to the input bay.
Console Metering
To Next Page
Loading...
