TEC0020 2018JAN3 P/N: 630-00025 Rev D AL600 & AL690 Hybrid Installation & Owner's Manual
23
SECTION 2 : INSTALLER
Installation - AL690
24"
36"
3B. If Seat Attachment Points are NOT Available:
Look under vehicle in approximate area where Leg will
need to be mounted. [Figure 23-1]
4. Installing the Rear Leg. The AL690’s rear leg will be
installed approximately 24” to 36” from the front leg.
[Figure 23-2]
The uprights on both legs must be in line and square.
Verify by measuring corner to corner. Distance should
be identical. [Figure 23-3]
LEG
FRONT LEG
IN-LINE
REAR LEG
FRONT LEG
24-36"
SURE
""X
=
""X
Figure 23-1
Look under vehicle in approximate area where leg
will need to be mounted.
Drill a pilot hole rst, up from under
the vehicle to ensure nothing will be
damaged.
Find hole from inside vehicle and drill
3/8” hole down through vehicle’s oor.
Figure 23-2
Figure 23-3
False oor support available
when applicable for vehicles
with Stow & Go seating. (2nd
row seats must be removed)
CAUTION
USE EXTREME CAUTION
Avoid Gas Tank, Fuel / Brake /
Electrical Lines
To Next Page
Loading...
