34 Chapter 2 | Installation and Setup
InfoCaster R2100 Hardware Installation Manual
Set Up Edit & Playback Without Catalyst Control Center
If you have just the ATI drivers and no Catalyst Control Center, follow these
instructions to configure Edit & Playback output.
1 Connect and turn on the monitors.
2 Right-click on the Windows desktop.
3 Select Properties to open the Display Properties dialog.
4 Switch to the Settings tab.
Figure 2-24. Display Properties Settings Tab
5 Select the monitor 2 icon.
6 Ensure your ATI card is listed under Display. If the ATI card is not listed:
a Click on the Advanced button.
b Switch to the Monitor tab.
c Click on the Properties button.
d Select Use this device (enable) from the Device usage drop-down list.
e Click on OK, then OK again to return to the Settings tab.
7 Select the Extend my Windows desktop onto this monitor checkbox.
8 Click on the Advanced button.
9 Switch to the Displays tab.
10 Select Monitor, and click Apply.
To Next Page
Loading...