______________________________________________HARRIS
888-9058-001
WARNING: Disconnect and lockout AC primary power prior to servicing
73
NOTE:
If connection cannot be made, try
setting the remote computer to a
fixed IP address. Select “Use the
following IP address” as shown to
the right. Then enter the IP address
192.168.217.1 with a subnet mask of
255.255.255.0 (this address is only
valid if you have eCDi™ software
revision 2.6.K or higher). Try Step 2
again. If it still does not work, try
several different ethernet cables.
NOTE:
If you have an eCDi™ software
revision before 2.6.K then enter you
must set a fixed IP address of
192.168.0.1 with a subnet mask of
255.255.255.0
To Next Page
Loading...
