VCA / VDA / VEA6800+ Installation and Operation Manual 3
Chapter 1: Introduction
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
• Module presence reporting via +Pilot Lite control system
• Hot swappable
VDA6800+
The VDA6800+ is a high performance, cost efficient, general purpose
analog video distribution amplifier. Composite and component analog
NTSC, PAL, SECAM signals (with sync or without sync), subcarrier,
and coaxial version AES digital audio signals can be amplified with the
VDA6800+ in FR6802+ series frames. Other VDA6800+ features
include the following:
• One differential input
• Eight outputs with dual slots back module, four outputs with single
slot back module when installed in FR6802+X(F) frames; eight
outputs when installed in FR6802+DM(F) frames
• DC input coupling
• Looping and internal terminating selectable with dual slot back
module, internal terminating with single slot back module with
FR6802+X(F) frames; looping or internal terminating selectable
with FR6802+DM(F) frames (see Figure 2-7 on page 21 for
instructions on setting this jumper)
• ± 3dB gain adjustable range
• > 50 MHz bandwidth
• Module presence reporting via +Pilot Lite control system
• Hot swappable
VEA6800+
The VEA6800+ is a high performance analog video equalizing
distribution amplifier. Composite and component analog NTSC, PAL,
SECAM signals, with or without sync, and subcarrier signal can be
amplified with VEA6800+ in FR6802+ series frames. Other
VEA6800+ features include the following:
• One differential input
• Eight outputs with dual slots back module, four outputs with single
slot back module when installed in FR6802+X(F) frames; eight
outputs when installed in FR6802+DM(F) frames
• DC input coupling
To Next Page
Loading...
