Hawk Gladiator - Installation with Adjustable Mounting

11
Mounting
Gladiator Gen 3 Microwave Series
Installation With Adjustable Mounting
XX
Product Flow
Sending Unit
Receiving Unit
Isolation Mount
Adjustable microwave mounting bracket
MA-12 or MA-13 welded to vessel wall.
UHMW (MA-12) or Teflon (MA-13) Window.
X = 30° Maximum
Hopper/Feeder
Mounting of a Microwave system on sloped vessel
walls can be accomplished using the Microwave
Adjustable Mount (MA-12 or MA-13). This system
allows the microwaves to be mounted to a sloped
surface and then adjusted horizontally for optimum
performance and operation. The adjustable mount
has an integral 4” weldment with UHMW polyethylene
or PTFE (Teflon) window options. An option with the
bracket is a vibration isolation kit (shock mounts)
to help protect the electronics from damage. Each
side wall of the vessel must not exceed 30 degrees
from the vertical centerline. To mount the adjustable
bracket, simply cut a hole and weld the 4” weldment
directly to the vessel, install the window, mount the
microwave and adjust horizontally.