Hawk Gladiator - Functionality Layout - Integral System

Functionality Layout - Integral System
Gladiator Gen 3 Microwave Series
18
Sender Receiver
(1) Sender status LED
• Blinks while working correctly.
• Solid while not transmitting.
(2) TEST button
• Press and hold to test level relay action.
(3) Sensitivity dial
• Turn clockwise for switching in clean environments and
object detection.
• Turn counter-clockwise for difficult applications, dusty/
wet environments.
(4) Hi / Lo switch
• Hi mode for clean environments and object detection.
• Lo mode for difficult applications, dusty/wet environments.
(5) FSH / FSL switch
• FSH relay normally closed.
• FSL relay normally open.
(6) Receiver status LEDs
• Green - High illumination for good signal,
Low illumination for weak signal.
• Red - Relay indication. Illuminated when closed.
• Blue - Cal mount indication - flashes during Cal
mount, will stay illuminated if Cal mount fails.
(7) Cal Mount switch
• Cal mount conducts the automatic setup routine for the
system. Perform Cal mount for all new installations, and
after adjusting either Sensitivity pot or Hi/Lo switch.
• Switch up to initiate Cal mount, wait several seconds,
then switch back down. Unit will automatically complete
Cal mount routine.
(8) Test switch
• Can be used for a failsafe / test relay. See full manual
for further information.
(9) Delay pot
• Rotate clockwise to increase Relay on/off delay time.
(10) Signal contact
• Signal can be read with voltmeter across Signal
contact point and earth screw (or other ground
reference). 2.4-2.5V is full signal. 0V is no signal.
D
e
l
a
y
2.5 Sec
0.5 Sec
15 Sec
Functionality Layout - Integral System
**
**
D
e
l
a
y
FSHHI
LO FSL
CAL TEST
OFF
OFF
Signal
S
e
n
s
i
t
i
v
i
t
y
microwave sender
STATUS
ON
1 2
ON
1 2
D
e
l
a
y
FSHHI
LO FSL
CAL TEST
OFF
OFF
Signal
S
e
n
s
i
t
i
v
i
t
y
1 2 3 4 5 6 7 8 9 10
ON
1 2
ON
1 2
3
4
5
6
7
9
microwave sender
STATUS
1
2
10
8
remote
Signal
STATUS
3
4
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10