Hawk Gladiator - Software Menu and Flow Charts; Remote Amplifier Software Menu Navigation

Remote Software
Gladiator Gen 3 Microwave Series
25
Parameter Description Sub Menu
Switch Mode
• Auto - Switch On% set in Quickset,
Switch Off% automatically configured
• Manual - Manually adjust Switch On and Switch Off %
• Off - Switch mode disabled in Analog (Density) mode
• Switch On%
• Switch Off%
Relay2Action
Set Relay2Action as one of the below:
• Failsafe - Relay2 triggers on failsafe conditions
• Relay2 - Mirrors Relay1 action to act as a second / backup
relay for the system
• Maintnce Chk* - Triggers Relay2 at a pre-defined Gain value
for a maintenance / build up alarm
• GainOPpt Cln* - Triggers Relay2 to activate a cleaner system
based on total Gain used
• TimeOpt Cln* - Triggers Relay to activate a cleaner system
based on a programmed time delay
* For further information about
the Maintenance and Cleaner
Relay2 alarms see 'Relay 2
Actions' on next page
View Log
Sets the unit to Boom Protection mode. This can also be used
for machinery / truck or object detection & collision avoidance
Reset Log
Sets the unit for blocked chute mode. Note that this mode may
be unsuitable for very low dielectric materials.
Comms Type
Adjust & select additional communications, baud rate and
device ID. All GSA units by default include Modbus.
• DeviceNet (not functional)
• Profibus (not functional)
• HART (not functional)
• Modbus
Back Light Turn on / off LCD backlight
Operating
Mode
• Remote: Default setting for standard remote system
• Master: Set system to Master mode for 2 system anti-crosstalk
• Slave: Set system to Slave mode for 2 system anti-crosstalk
For further information see
'Cross Talk Prevention /
Sequencer Wiring' section
Display Span
Probe Avg
Probe Avg is a output damping parameter.
Increase to smooth out unwanted fluctuations or instability.
LoadDefaults Reset system to defaults (amplifier and/or sensor)
InputVolChk
Used for power related failsafe. When active the unit will switch
to failsafe mode if input voltage drops below required power.
When not active unit will display ‘Input Voltage too low' on the
display if input voltage drops below required power.
Advanced Menu - Parameters