What to do if the Sensor Value change is too small on my Hawk Gladiator Switch?
If the Sensor Value change is too small on your Hawk Switch, you can change the Display Span in the Advanced menu. This will expand the display resolution.
Power| operating voltage | 12-30VDC, 90-260VAC, 36-60VDC |
|---|---|
| power consumption | <0.8W @ 24VDC, <5VA @ 240Vac, <3VA @ 115Vac |
Operating Environment| maximum operating pressure | 2 BAR |
|---|---|
| operating temperature for remote electronics | -40°C (-40°F) to 80°C (176°F) |
| operating temperature for remote sensors | -20°C (-4°F) to 80°C (176°F) |
| enclosure sealing for remote electronics | IP67 (NEMA 4x) |
| enclosure sealing for remote sensors | IP68 |
Weight and Dimensions| transducer to amplifier separation | Up to 500m (1640ft) |
|---|---|
| typical weight for 15kHz transducer | 8 kg |
| typical weight for remote amplifier | 1 kg |
Explains how the admittance switch operates using dielectric constant changes.
Covers points to consider, correct, and incorrect mounting practices and diagrams.
Details the wiring connections for the Smart Probe version.
Explains how to wire the remote probe to the amplifier.
Details the layout and function of switches and LEDs on the Smart Probe.
Step-by-step guide for setting up the Smart Probe version.
Describes the buttons, LEDs, and display on the Remote unit.
Step-by-step guide for setting up the Remote version.
Describes remote communication capabilities using GSM/CDMA.
Guides users through checking setup and troubleshooting common issues.
To Next Page
