What to do if the Sensor Value change is too small on my Hawk Gladiator Switch?
If the Sensor Value change is too small on your Hawk Switch, you can change the Display Span in the Advanced menu. This will expand the display resolution.
Power| operating voltage | 12-30VDC, 90-260VAC, 36-60VDC |
|---|---|
| power consumption | <0.8W @ 24VDC, <5VA @ 240Vac, <3VA @ 115Vac |
Operating Environment| maximum operating pressure | 2 BAR |
|---|---|
| operating temperature for remote electronics | -40°C (-40°F) to 80°C (176°F) |
| operating temperature for remote sensors | -20°C (-4°F) to 80°C (176°F) |
| enclosure sealing for remote electronics | IP67 (NEMA 4x) |
| enclosure sealing for remote sensors | IP68 |
Weight and Dimensions| transducer to amplifier separation | Up to 500m (1640ft) |
|---|---|
| typical weight for 15kHz transducer | 8 kg |
| typical weight for remote amplifier | 1 kg |
To Next Page
