Hawk Gladiator - Wiring; Smart Probe Wiring Diagram

User Interface
Gladiator Acoustic Switch Series
13
Facia Controls
Gladiator Amplier
CAL
RUN
RELAY 1 RELAY 2 STATUS A STATUS B
1
2
3
4
6
7
5
1
2
3
4
5
6
7
Calibrate button
Down button
Up button
Relay LEDs 1 and 2
Run button
Display (LCD with backlight)
Status LEDs A and B
Status A blinking indicates units are pulsing correctly.
Status B is not used
In Run Mode
(A) Press and hold - interrupts normal operations and allows access to software menu headings.
In Calibrate Mode
(B) Steps into a menu selection to allow editing (down one level)
(C) Saves selected value and moves onto the next menu item.
In Run Mode
(A) Hides diagnostics if they are in view and returns to the standard running display.
In Calibrate Mode
(B) Steps out of a menu or selection (up one level). Parameter value will be stored automatically
when stepping up.
(C) Returns to running mode from the top level menu.
In Run Mode
(A) Scrolls through operating diagnostics on display LCD.
In Calibrate Mode
(B) Scrolls through software parameters when browsing the menus.
(C) Changes display value when editing a parameter.
All software adjustments can be made by the push buttons on the amplifier facia.