Hawk Gladiator - HawkLink GSM Power and Comms Wiring

16
Admittance Smart Switch Series
Manual
Rev 1.2, June 2008
17
Connect shield to
DC “-” only at this end.
1 2 3 4
1 2 3 4
1 2 3 4

-
Existing DC power supply
Existing AC power
supply (GSM will be
powered by DC
generated by the Gladiator)
COMMS DC-IN
A
B
12-30VDC
GSM

RS 485
AC-IN
N
L1
80-265VAC
COMMS DC-IN
A
B
12-30VDC
GSM

RS 485
AC-IN
N
L1
80-265VAC
COMMS DC-IN
A
B
12-30VDC
REMOTE AMP

RS 485
AC-IN
N
L1
80-265VAC
COMMS DC-IN
A
B
12-30VDC

RS 485
-
Connect shield to
DC “-” only at this end.
1 2 3 4
2 1 4 3
SMART PROBE
COMMS DC-IN
A
B
12-30VDC
GSM

RS 485
AC-IN
N
L1
80-265VAC
Connect shield to
DC “-” only at this end.
1 2 3 4
COMMS DC-IN
A
B
12-30VDC
REMOTE AMP

RS 485
AC-IN
N
L1
80-265VAC

-
Existing DC power supply
USING DC POWER FROM GLADIATOR SMART PROBE
USING DC POWER DERIVED FROM AC POWERED REMOTE GLADIATOR
USING DC POWER FROM REMOTE GLADIATOR
WIRING
HAWKLINK GSM - CONNECTING POWER AND COMMS
!
NOT POSSIBLE WITH
GLADIATOR SMART
PROBES. INTERNAL
POWER SUPPLY HAS IN-
SUFFICIENT CAPACITY.
!
TERMINAL ORDER VARIES BETWEEN GLADIATOR SMART PROBE
AND REMOTE AMPLIFIER. ENSURE CORRECT LAYOUT IS USED.