Hawk Gladiator - Default Chapter; Table of Contents

Table of Contents
Gladiator Gen 3 Microwave Series
2
Contents
PROPRIETARY NOTICE
The information contained in this publication is derived in
part from proprietary and patent data. This information has
been prepared for the express purpose of assisting operating
and maintenance personnel in the efficient use of the
instrument described herein. Publication of this information
does not convey any rights to use or reproduce it, or to use
for any purpose other than in connection with the installation,
operation and maintenance of the equipment described herein.
WARNING
This instrument contains electronic components that are
susceptible to damage by static electricity. Proper handling
procedures must be observed during the removal, installation,
or handling of internal circuit boards or devices:
Handling Procedure:
1. Power to unit must be removed prior to commencement of
any work.
2. Personnel must be grounded, via wrist strap or other safe,
suitable means, before any printed circuit board or other
internal devices are installed, removed or adjusted.
3. Printed circuit boards must be transported in a conductive
bag or other conductive container. Boards must not be
removed from protective container until the immediate time
of installation. Removed boards must be placed immediately
in a protective container for transport, storage, or return to
factory.
Overview 3
Principle of Operation 3
Typical Uses 3
Function 3
Features 3
Dimensions 4
Remote Microwave System 4
MA Series Weldments and Windows (UHMW / PTFE) 5
MA Series Weldments and Windows (Ceramic) 6
MD Series Weldments and Windows 7
Weldments and Windows
(Ceramic Tile & Firebrick Assemblies) 8
Mounting 9
General Guidelines 9
Mounting With Windowed Weldments 10
Installation With Adjustable Mounting 11
Correct Mounting Angle 12
Align Sender and Receiver 12
Wiring 13
Remote System Connection - HAWK Supplied Cable 13
Remote System Connection - Customer Supplied Cable 14
Alternate Cable Type Between Amplifier and Sensors 14
Integral System Connection 15
Wiring - Relay Functions 16
Functionality Layout - Remote System 17
Functionality Layout - Integral System 18
Setup Procedure 19
Setup Procedure - Remote System 19
Setup Procedure - Integral System 20
Remote Software 21
Operational Diagnostics 21
Main Menus & Interface 22
Quickset Menu - Parameters 23
App Types - Parameters 24
Advanced Menu - Parameters 25
Relay 2 Actions 26
Relay 2 Software Flow Chart 27
Cross-Talk Prevention 28
Cross-Talk Prevention - Remote 28
Cross-Talk Prevention - Integral Systems 29
Wiring 29
System Calibration 29
Integral Test Switch 30
Integral Receiver Test Switch Functions 30
Troubleshooting 31
Error Codes 32
Safety Information 33
FCC Regulations 33
Part Numbering 34
Remote Version 34
Integral Version 35
Accessories 35
MA Series Mounting Accessories 36
MD Series Mounting Accessories - Kit 36
MD Series Mounting Accessories - Parts 37
Specications  39